|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
13-06-2009, 06:31 AM
|
#1 | ||
|
Regular Member
Join Date: Jun 2009
Posts: 33
|
I trying to replace a rear seat belt but finding it hard to get to the anchour points. Any tips on getting the belt out? Thanks
|
||
|
|
|
14-06-2009, 07:21 PM
|
#2 | ||
|
Donating Member
 Join Date: Dec 2006
Posts: 5,545
|
The centre one is under the parcel shelf and the outer ones are behind the c pillars plastic
Other end is under the seat cushion |
||
|
|
|
|
15-06-2009, 06:03 AM
|
#3 | ||
|
Regular Member
Join Date: Jun 2009
Posts: 33
|
thanks
the ones under the C pillar plastic are not the easiest to get to. I'll just take it to the shop and get them to change it |
||
|
|
|
|
15-06-2009, 07:48 PM
|
#4 | ||
|
Donating Member
Join Date: Dec 2006
Posts: 5,545
|
Take off rubber door seal that edges against the plastic, and then pull it off, just held in by spring clips
Very easy, then undo seat belt, need torx bit to undo The middle one is the harder one |
||
|
|
|
AU111 seat belt
Linear Mode
